The photos on these pages are designed
to help you identify the end fittings and/or adapters for the brake line
assemblies you require. Please note that brake line fittings (vs. adapters)
are permanently attached to the stainless steel braided PTFE brake line
assembly by either crimping or swaging the barb or insert part of the fitting
into the hose. The photo below is of the barb section of a fitting, so when
examining the end fitting on your brake line assembly, you will not see
this part of the fitting!
3/8-24 Female Inverted Flare w/ Clipgroove
10mm Copper Crush Washer .030 Thick
7/16-24 Female Inverted Flare w/ Clipgroove
L-Bracket
Spring Clip
10mm 1.0 Female Flared w/ Clipgroove
10mm 1.0 Female Flared with no Clipgroove
E-Clip
10mm 1.0 Female Inverted Flare w/ Clipgroove
3/8-24 Female Inverted Flare Bulkhead Fitting
10mm Crush Washer .050 Thick
10mm 1.0 Male Inverted Flare
10mm 1.0 Male Bubble Flare
-3 Male JIC by 3/8-24 Female Adapter
-3 Male JIC by 3/8-24 Male Inverted FlareAdapter
3/8-24 Inverted Flare w/ one side port and one mounting hole
3/8-24 T-Block w/ two side ports and one mounting hole